Optimize the warming up condition, to avoid a long wait period before aircraft can takeoff. So, for any who have this same issue, here's what I recommend: Obviously, they have an issue that they're not addressing consistently in their tech support department; not to mention that they have a bug on the firmware update routine of their iOSD Assistant 4. Firmware mismatch and I couldn't get back to the mainscreen to move data on Left side. I found a work around to downgrade back to V1. I can't guarantee this will work for everyone, but I had the same problem. 
| Uploader: | Tumi |
| Date Added: | 3 April 2011 |
| File Size: | 56.89 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 81402 |
| Price: | Free* [*Free Regsitration Required] |
Manual Add connection diagrams when used with other DJI products.
Install driver and assistant software | DJI iOSD mini User Manual | Page 3 / 5
I bought a ready made harness and everything worked until I went into upgrading iOSD firmware. Called them on the phone, after a bit of investigating, they want me to send it back for repair, which I don't want to do. This site uses cookies.
I've also noticed that it has become much harder to find the support page downloads, etc.
Parameter configuration by NM Assistant is supported. But then I noticed that my changes were not being written and saved. The password mechanism ensures your safety link.
Hey Crossbones - I replied to your PM on this subject. It uses low power Bluetooth softwarf minimize the power consumption of your mobile devices. They responded very fast to me. Has anyone else experienced this?
You can down load the iOSD Assistant 4. The time now is Thread Tools Show Printable Version. But I went ahead and updated. Similar Threads How can I upgrade the software in my to the latest and greatest?
Install driver and assistant software – DJI iOSD mini User Manual
Are you able to describe the steps you went through to roll the firmware back? It's not a very obvious procedure. When it started again, it gave me the same firmware message! Now - for those who have already contacted tech support via email For safety reason, do not use power battery during firmware upgrade.
Had just finished fixing a P2 purchased O. Software will ask if you want to "upgrade" to V1.
Both were very helpful. And yet again, the values I entered would not write. Just tick me off that I got into this problem just because I followed the directions. Obviously, they have an issue that they're not addressing consistently in their tech support department; not to mention that they have a bug on the firmware update routine of their iOSD Assistant 4. That's why I'm encouraging everyone to email support.
Everything went fine, the firmware upgrade completed successfully,and I was able to go to the main screen. It appears to me that DJI may be moving away from the individual components and focusing on complete multirotor airframes - but that's conjecture on my part and a subject for another thread.
Try sending an support email to them through their www. By husafreak in forum ImmersionRC.
Make sure to reconfigure all parameters in the assistant software after upgrading firmware, since V3. Sssistant working fine, it would just be nice to write to it to suit my FPV display.
Me, too, did exactly the same - before I found this thread. Time after time I saw the message:
No comments:
Post a Comment